Hellwig 1801 EZ Level Helper Spring Kit

You looking to find the "Hellwig 1801 EZ Level Helper Spring Kit" Good news! You can purchase Hellwig 1801 EZ Level Helper Spring Kit with secure price and compare to view update price on this product. And deals on this product is available only for limited time.

Price: $139.97    

Product Feature

• Variable rate leaves do not affect ride when unloaded
• High quality spring steel leaves
• Adds new life to old springs and reduces body roll

Product Description

EZ level which has 2000 pounds level load capacity can be adjusted independently for uneven side to side loads. Complete bolt on and backed by lifetime warranty. Variable rate leaves do not affect ride when unloaded. Has high quality spring steel leaves. Adds new life to old springs and reduces body roll.

Hellwig 1801 EZ Level Helper Spring Kit Review

I installed these on my 1994 GMC half ton 4 wheel drive flat bed and I am quite pleased. My leaf springs were tired, the bed would sag with a load and when empty the springs made lots of noises. I added this helper spring set and my truck has new vigor. The noises are gone and the truck tends to remain more level.

The instructions were a little generic, I am not a mechanic and I am old but these were easy to install and I figured out the adjustments. I was going to post pictures but Amazon said they are not going to allow this any more, so I will try to explain.

It took me working alone about 3 hours to complete the job, this includes making test drives and adjustments, realistically I think the job could be done sooner. I tend to be over cautious. I found it best to jack up the vehicle, remove the wheels and support the frame and then lower the rear axel so your existing spring will sag and make it easier to secure the helper spring.

Read the instructions (although vague) especially the last page about adjustments. They tell you to torque bolts and give a chart based on the bolt size, in this case they are half inch bolts. Each spring sets on top of your existing leaf and has 4 mounting points the only bolts to torque are the two mounts closest to your axel. The bolth at the ends are where you make your adjustments. All bolts are double nutted once all adjustments are complete.

I recommend for tired or noisy leaf springs, the helpers are heavy steel and appear to be good quality and the average do-it yourselfer can easily accomplish this install.

7-30-2013 Update. Per the instructions I re-checked my installation and found that things have settled and required some additional tightening. Be sure to re-check your bolts and adjustments after some use.

Most of the consumer Reviews tell that the "Hellwig 1801 EZ Level Helper Spring Kit" are high quality item. You can read each testimony from consumers to find out cons and pros from Hellwig 1801 EZ Level Helper Spring Kit ...